Nikon D3000 - Manual (Page 60)

54
n
This card is not formatted.
Format card? T
(blinks)
Format card or turn camera off and insert new memory
card.
Card is full
j
(blinks)
• Reduce quality or size.
• Delete photographs.
• Insert new memory card.
—
●
(blinks)
Camera can not focus using autofocus. Change
composition or focus manually.
Subject is too bright. q
• Use a lower ISO sensitivity
• Use commercial ND filter
• In mode:
S Increase shutter speed
A Choose a smaller aperture (larger f-number)
Subject is too dark. r
• Use a higher ISO sensitivity
• Use flash
• In mode:
S Lower shutter speed
A Choose a larger aperture (smaller f-number)
No Bulb in S mode.
A
(blinks)
Change shutter speed or select manual exposure mode.
&
(blinks)
—
N
(blinks)
Flash has fired at full power. Check photo in monitor; if
underexposed, adjust settings and try again.
Flash is in TTL mode. Choose
another setting or use a CPU
lens.
Change flash mode setting on optional flash unit or use
CPU lens.
—
N/s
(blinks)
• Use the flash.
• Change distance to subject, aperture, flash range, or
ISO sensitivity.
• Optional SB-400 flash unit attached: flash is in bounce
position or focus distance is very short. Continue
shooting; if necessary, increase focus distance to
prevent shadows from appearing in photograph.
Flash error
Error occurred updating firmware for optional flash unit.
Contact Nikon-authorized service representative.
Error. Press shutter release
button again.
O
(blinks)
Release shutter. If error persists or appears frequently,
consult Nikon-authorized service representative.
Start-up error. Contact a
Nikon-authorized service
representative.
Consult Nikon-authorized service representative.
Autoexposure error. Contact
a Nikon-authorized service
representative.
Indicator
Solution Monitor Viewfinder