Messages – Aiwa XR-EM550 User Manual

Page 25

Advertising
background image

T

ro

ub
les
hoo

ting

25

GB

• Refer to the operating instructions supplied with

the connected component and start playing.

• Press FUNCTION repeatedly until “MD” appears

(page 22).

The sound is distorted.

• Set the volume of the connected component

lower.

If the system still does not
operate properly after performing
the above measures, reset the
system as follows:

Use buttons on the unit for the operation.

1

Disconnect the power cord.

2

Reconnect the power cord.

3

Press

?/1

to turn on the system.

4

Press

x

,

?/1

and turn volume to the left at

the same time.

The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.

One of the following messages may appear or
flash in the display during operation.

CD/MP3

NO DISC

There is no disc in the player.

NO STEP

All of the programed tracks have been erased.

OVER

You have reached the end of the disc while pressing
and holding M during playback or pause.

STEP FULL

You tried to program 26 or more tracks (steps).

PUSH STOP

You pressed PLAY MODE during playback.

Tuner

COMPLETE

The preset operation ended normally.

Tape

NO TAB

You cannot record the tape because the tab has been
removed from the cassette.

NO TAPE

There is no tape in the tape deck.

Timer

SET CLOCK

You tried to select the timer with the clock not set.

PUSH SELECT

You tried to set the clock or timer during timer
operation.

SET TIMER

You tried to select the timer when Play Timer or Rec
Timer are not set.

TIME NG

Play Timer or Rec Timer start and end times are set
to the same time.

Messages

continued

Advertising
This manual is related to the following products: