Alliance Laundry Systems UW35M2 - Manual (Page 21)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 19 F232088
Programming
The wash cycle program in machines equipped with a
mechanical timer can be modified to a limited extent.
The following changes can be made:
● The prewash time may be set to 2 minutes, 4
minutes, or omitted altogether.
● The wash time may be set to either 4 minutes or 8
minutes. The water level for the wash step may
be set to either low or high.
● The water temperature for the rinses may be set
to either cold or warm.
● The final spin time may be set to either 2 minutes
or 4 minutes.
Setting the Jumpers
NOTE: The following procedures must be
performed by a qualified electrician familiar with
the construction and operation of this type of
machinery.
1. Disconnect power to the machine.
2. Remove the screws securing the control module
cover to the control module.
3. Lift the control module cover and slide cover
towards the rear of the machine.
4. The mechanical timer is located in the control
module. The odd-numbered side of the timer is
used to change the duration of individual cycle
steps. See Figure 4.
Eleven permissible jumper configurations are
available for changing the cycle time. See the
table below.
Figure 4
This machine must be installed, adjusted,
and serviced by qualified electrical
maintenance personnel familiar with the
construction and operation of this type of
machinery. They must also be familiar
with the potential hazards involved.
Failure to observe this warning may result
in personal injury and/or equipment
damage, and may void the warranty.
SW004
WARNING
Dangerous voltages are present in the
electrical control box(es) and at the motor
terminals. Only qualified personnel
familiar with electrical test procedures,
test equipment, and safety precautions
should attempt adjustments and
troubleshooting. Disconnect power from
the machine before removing the control
box cover, and before attempting any
service procedures.
SW005
WARNING
Attempting jumper configurations other
than those described in this manual may
result in personal injury and/or equipment
damage, and may void the warranty.
SW041
WARNING
1b 1 1a
3b 3 3a
5b 5 5a
7b 7 7a
9b 9 9a
11b 11 11a
13b 13 13a
15b 15 15a
17b 17 17a
19b 19 19a