Indesit HI-20.A-(WH)-1 - Manual (Page 10)

10
GB
Electrical connections
The cooker must be connected to the mains electricity
supply. It is designed to operate with alternating
current at the voltage and frequency indicated on the
data plate (see the following page).
The hob is connected to the cooker using a special
connector.
BUILT-IN HOB
BUILT-IN COOKER
WHITE RED YELLOW BLUE GREEN
Only on
certain models
Replace the metal protection after performing all the
necessary hob connections. If the hob is removed from
its position, the red cap which was originally protecting
the red connector must be replaced.
Fitting the power supply cable
1. Open the terminal
board by inserting a
screwdriver into the side
tabs of the cover. Use
the screwdriver as a
lever by pushing it down
to open the cover (see
diagram
).
2. Install the power supply cable by loosening the
cable clamp screw and the wire contact screws L-N-
. Connect the wires to the corresponding terminals:
the Blue wire to the terminal marked (N), the Brown
wire to the terminal marked (L) and the Yellow Green
wire to the terminal marked
.
The terminal board is designed for a 400 V three-phase
connection (see diagrams below).
If the electrical system has other characteristics (see
diagrams below
), carry out the electrical connection
using the connection supports provided in the box P.
3. Secure the power supply cable by fastening the
clamp screw.
4. Close the cover of the terminal board.
N L1 L3 L2
1 3
2 4
5
N
L2
L1
L3
P
N L
1 3
2 4
5
N L1 L2
1 3
2 4
5
400V 3N~
H05 RR-F5x2.5 CEI-UNEL 35363
H05 VV-F5x2.5 CEI-UNEL 35746
230V~
H05 RR-F 3x4 CEI-UNEL 35363
H05 VV-F 3x4 CEI-UNEL 35746
400V 2N~
H05 RR-F4x4 CEI-UNEL 35363
H05 VV-F4x4 CEI-UNEL 35746