A.J. Antunes & Co HDC-50A 9300360 - Manual (Page 7)

Hot Dog Corral
7
A.J. Antunes & Co.
P/N 1010609 Rev. I 03/12
figure 1. Hot Dog Corral
Driver frame
unpacking
1. Remove unit and all packing materials from
shipping carton.
2. Open the large box. Remove all packing
materials and protective coverings from the unit
and parts.
nOte: If any parts are missing or damaged,
contact antunes technical service ImmeDIately at
1-877-392-7854.
3. Wash driver frame in soap and water. Wipe all
surfaces of the unit with a hot damp cloth.
nOte: Do nOt use a dripping wet cloth. wring out
before use.
4. Install driver frame onto unit.
equipment setup
When placing the unit into service, pay attention to the
following guidelines:
• Make sure power is off and the unit is at room
temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
• Place unit on a sturdy, level table or work surface.
ensure that the line voltage corresponds to the stated
voltage on the unit specification label.
turn the Rocker switch (Power On/Off) to Off.
connect the unit to the power supply.
InstallatIOn
CautIOn
all electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
warnInG
eleCtrICal sHOCK HazarD. faIlure tO
fOllOw tHe InstruCtIOns In tHIs manual
COulD result In serIOus Injury Or DeatH.
• Electrical ground is required on this appliance.
• Do NOT modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do NOT use an extension cord with this unit.
• The unit should be grounded according to local
electrical codes to prevent the possibility of
electrical shock. It requires a grounded recep-
tacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.
• Check with a qualified electrician if you are
unsure if the unit is properly grounded.