A.J. Antunes & Co MS-150 9100429 - Manual (Page 5)

5 P/N 1010881 Rev. F 03/12
inSTallaTion
1. Remove the unit and all packing
materials from the shipping carton.
2. The unit should come with the items
listed below:
• Owner’s Manual
• Authorized Service Agency Directory
• Spatula Assembly
NotE: If any parts are missing or dam-
aged, contact a.J. antunes IMMEDIatELY
at 1-800-253-2991 or 1-630-784-1000.
3. Remove all packing materials and pro-
tective coverings from the unit.
4. Remove and wash the Wire Trivet,
Spatula, Spatula Liner, and Drip Pan
(Figure 1) in soap and water. Rinse
with clean hot water and allow to air
dry.
5. Wipe all surfaces of the unit with a
hot, damp cloth.
NotE: Do Not use a dripping wet cloth.
Wring out before use.
6. Assemble the Handle, Handle Guard
and Mounting Bolt to the Spatula
(Figure 2).
7. Install the Wire Trivet into the side
slots on the Spatula (Figure 2).
8. Re-install all removed parts.
When placing the unit into service, pay atten-
tion to the following guidelines:
• Make sure power is off and the unit is
at room temperature.
• Do NOT block or cover any openings
on the unit.
• Do NOT immerse cord or plug in
water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge
of table or counter.
Spatula
Wire trivet
Drip pan
Spatula Liner
Figure 1. Washing parts
Figure 2. assembling Handle
Bolt
Handle
Spatula
Handle Guard
Wire trivet
elecTrical
Plug the power cord into the appropriate
power outlet. Refer to the specification plate
for the proper voltage.
1. Place the unit on a sturdy, level table
or other work surface.
2. Turn off the power.
3. Ensure that the line voltage corre-
sponds to the stated voltage on the
units specification label and power
cord warning tag. If you are unsure of
your Line Voltage, contact an electri-
cian.
4. Connect the unit to the power supply.
WarNING
Be sure to follow all the precautions, proce-
dures, and safety steps listed in the Important
Safety Information section of this manual.
WarNING
All electrical connections must be in accor-
dance with local electrical codes and any other
applicable codes.
pluMbinG
NotE: Miracle Steamer models are
designed to use cold tap water. Distilled
water may be used to reduce calcium/
mineral deposit buildup and reduce main-
tenance costs.
The MS-150 models have a self-contained
water tank. To fill the self-contained water
tank:
1. Open the Tank Cover on top of the
unit (Figure 3).
NotE: Make sure filter inside tank is
installed properly.
2. Pour in cold tap water. The tank will
hold approximately 3 quarts (2.81
liters).
3. Close the Tank Cover.
NotE: Do Not overfill the unit’s water
tank. only fill the tank to 90% full.
READ Y
Figure 3. Filling Water tank
Filter
tank Cover
tank