A.J. Antunes & Co MS-150 9100429 - Manual (Page 7)

7 P/N 1010881 Rev. F 03/12
Daily MainTenance
1. Turn the power off, unplug the power
cord, and allow the unit to cool down
before proceeding.
2. Remove the Spatula, Liner, Drip Pan,
Top Cover, and Steam Vent (Figure 6).
3. Wash items in hot, soapy water and
then rinse and wipe dry.
4. Wipe down the food compartment
and the entire exterior of the unit with
a clean, hot, damp cloth (not dripping
wet) and wipe dry.
5. Reinstall the Steam Vent first, followed
by the remaining items.
NotE: Failure to properly clean and dry
the above mentioned items prior to reas-
sembling may result in the accumulation
of water/moisture overnight. this may
lead to permanent damage of the equip-
ment’s finish and its accessories. this
damage is not covered by warranty.
NotE: Frequency of cleaning is deter-
mined by water conditions, usage and
water filtration systems.
CaUtIoN
Do not use a sanitizing solution or abrasive
materials. The use of these may cause dam-
age to the stainless steel finish.
CaUtIoN
If a chemical cleaner is used, be sure it is
safe to use on cast aluminum. Observe all
precautions and warnings on product label.
WarNING
Turn the power off, unplug the power cord, and
all the unit to cool down before performing
any service or maintenance.
WarNING
Be sure to follow all the precautions, proce-
dures, and safety steps listed in the Important
Safety Information section of this manual.
Steam Vent
Spatula
Drip pan
Spatula Liner
top
Cover
Figure 6. Daily Cleaning–MS-150
GeneraTor TeMperaTure
The unit has three Generator temperature
options.
• Display of current Generator casting
temperature
• Changing of Generator setpoint tem-
perature
• Changing temperature units from
Fahrenheit (°F) to Celsius (°C) and
vice versa.
DISpLaYING GENErator
tEMpEratUrE
Press and hold to verify the actual
Generator temperature. The unit will display
the actual Generator temperature (Figure 5).
CHaNGING GENErator
tEMpEratUrE
To change the Generator setpoint tempera-
ture, press and hold and simultaneously
for three seconds (Figure 5). Then, press and
to raise or lower the temperature. Release
the buttons when the desired temperature
is reached. After 10 seconds, the display will
return to 15:00.
CHaNGING tEMpEratUrE DISpLaY
To change the display from Fahrenheit (°F)
to Celsius (°C), press and hold and
simultaneously for three seconds. Repeat the
process to reverse from Celsius to Fahrenheit.
Figure 5. Generator temperature
UP DOWN PROGRAM START/STOP
400F