A.J. Antunes & Co VS-200ADB 9100230 - Manual (Page 8)

8
Variety SteaMer
P/N 1010649 Rev. G 03/12
A.J. Antunes & Co.
Connect Quick
Disconnect
Insert Here
Front Legs
Raised
Slightly
Quick
Disconnect
Insert
Connect Black
Drain Hose Here
Inlet Hose &
Strainer Assy.
(Supplied)
Water Pressure Regulator
& Strainer Assy. P/N 7000314
(Not Supplied)
Shut Off Valve
(Not Supplied)
Cold
Water
Flow
Flexible Nylon Braided
1/4 " I.D. Tubing (Not Supplied)
warnInG
be sure to follow all guidelines, procedures, and
precautions listed in the important safety informa-
tion section of this manual.
figure 2. connecting water supply
plUmbInG
nOte: Variety steamer models are designed to
use cold tap water.
this unit requires a direct water hookup. a Water inlet
Hose and Strainer Assembly (Figure 2) are supplied.
1. Turn off the Water Valve (not supplied) that pro-
vides water to the unit (Figure 2).
2. Connect the 1/4” I.D. flexible tubing to the outlet
side of the Water Pressure Regulator and secure
with the Worm Clamp (Figure 2).
nOte: a water pressure regulator (p/n 7000314)
must first be installed (figure 2). failure to do so
will result in poor steaming and possible flooding.
3. turn on the Water Valve.
4. Hold the Quick Disconnect Insert over a bucket,
then press and hold the white plastic tip until
there’s a good, steady water flow. this will purge
all air out of the line.
caUtIOn
this equipment is to be installed to comply with
the basic plumbing code of the building Officials
and code administrators, Inc. (bOca) and the
food service sanitation manual of the food and
Drug administration (fDa).
5. Release the plastic tip and check the pressure on
the Water Pressure Regulator Gauge. it should
read 20 psi.
a.) If it reads less, increase the water pressure by
pulling the black knob up and turning it clockwise.
b.) If it reads more, decrease the water pressure
by pulling the black knob up and turning it counter
clockwise.
nOte: when adjusting the knob, you must relieve
the existing pressure by pressing the white plastic
tip on the Quick Disconnect insert for 3 seconds.
the gauge will then show the new pressure.
6. Once the gauge reads 20 psi, push the black
knob down to lock it in place.
7. Push the Quick Disconnect Insert into the fitting
at the rear of the unit until it clicks (Figure 2).
nOte: Incoming water is controlled by a solenoid
valve inside the electrical housing of the steamer.
8. Connect the Black Drain Hose to the Drip Tray
(Figure 2). Place the other end of the hose in a
drain or collection pan.
caUtIOn
water pressure must not exceed 30 psi (2.1
kg/cm2 or 207 kpa). Higher water pressure
may cause poor performance or flooding. to
reduce water pressure, install a water pressure
regulator, and set the pressure between 20–25 psi
(1.4–1.7 kg/cm2 or 138–172 kpa). to order a water
pressure regulator from your authorized service
agency, order roundup p/n 7000314.
InstallatIOn (continued)