elektraLite eyeBall QUAD 7x12w LEDs - Manual (Page 2)

1. Unpacking
Thank you for choosing the Elektralite eyeBall fixture. For your own safety, please read this manual
before installing the device. This manual covers important information on installation and applications.
Please keep this manual for future reference.
Elektralite eyeBall wash fixture uses 7 high powered 10 watt quad leds in a balanced arrangement
giving incredible output. Please unpack the Elektralite eyeBall carefully and check whether it was
damaged in shipping.
The following item should be in the box with the fixture:-
2 part yoke
2 knobs for yoke
1 DMX 5 pin cable
1 Turnaround 3 to 5 pin cable
1 Turnaround 5 to 3 pin cable
1 IEC power cable
1 IEC jumper cable (for joining fixtures)
2. Safety Instructions.
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual. Elektralite eyeBall is a high voltage fixture. Be careful when dealing
with high voltages.
Please read this manual. If you do not read this manual and damages occur to the Elektralite
eyeBall, then it could void the warranty.
During shipping, the Elektralite eyeBall may have been exposed to high temperature changes or
humidity changes. So, as a precaution, do not switch the Elektralite eyeBall on immediately.
Condensation can damage the Elektralite eyeBall so leave the Elektralite eyeBall switched off until it
has reached room temperature. The Elektralite eyeBall is an INDOOR operational fixture. Do not
operate this fixture outdoors or anywhere there is high humidity.
The electrical connection must carry out by a qualified person and it is absolutely essential that the
Elektralite eyeBall be grounded. So under no circumstances break off the ground pin on the Edison
plug or use the fixture where a ground is not present. A ground pin, like the fuse for the Elektralite
eyeBall is there for safety.
Always disconnect the Elektralite eyeBall from the power source, when the fixture is not in use or
before cleaning it. Only unplug Elektralite eyeBall from the power source holding onto the Edison plug.
Never pull out the Edison plug out by just pulling on the power cord itself.
Please keep the Elektralite eyeBall away from children and the general public. Please be intelligent
and use common sense when operating the Elektralite eyeBall.