elektraLite eyeBall QUAD 7x12w LEDs - Manual (Page 8)

Please note the DIM function under the Set menu in the fixture does not work when in the STAG mode.
When is STAG mode you can operate/access the DIM function directly through channel 10 on your
lighting controller.
4). REST
This resets all values to their default.
Go through the Root Menu until Set. Press Enter and then use the ↑ or ↓ buttons to get to REST. Press
Enter. The display will have 4 dots across the bottom. The password needs to be entered. The
password is the following sequence using the ↑ and ↓ buttons.
↑ ↓ ↑ ↓ press Enter once complete. The display will read OK followed by a return to the REST
sub menu. The Menu button will need pressing to return to the Root Menu. Only once at the Root
Menu will the dmx control function. Please note the Reset also takes the dmx address back to 001.
14. Fan.
The fans inside the eyeBall can be set to operate in a number of different ways.
They can be set to OFF, AUTO, LOW, NORMAL or HIGH.
To access and set one of these settings go through the Root Menu until FAN appears. Press Enter and
then use the ↑ or ↓ buttons to get to select the operating mode required. Press Enter to save this fan
setting.
15. KEY
The Key function is an access password for the fixture. The KEY can be turned OFF or ON which then
deactivates or activates the password.
To set the KEY go through the Root Menu until KEY. Press Enter and use the ↑ or ↓ to set the KEY to
either OFF or ON. If the Key is turned ON then a password is required to go into sensitive Menus and
to change functions.
The password is ↑ ↓ ↑ ↓ (Up + Down + Up + Down)