elektraLite MY 250 - Manual (Page 13)

12
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “LAMP”.
- Lamp on/off
This function switches the lamp on or off via the display panel.
1. Select
"OPEN" by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” if you wish to switch on the lamp or “OFF” if you wish to switch it off.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- Lamp on/off via external controller
This function switches the lamp on or off via an external controller like the Elektralite CP10xt.
1. Select
“ONLI” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- Delay lamp on
This function delays the lamp ignition.
1. Select
"DELA" by pressing [UP] button.
2. Press [ENTER] to confirm; the display shows “D-00”. In “D-00”, the lamp strikes immediately.
3. Press
[UP] to select the desired delay between "00" and "59" minutes.
4. If you select “D-03” the lamp will strike after 3 minutes.
5. Press [ENTER] to confirm.
6. Press [EXIT/DN] to return to the main menu.
- Main menu 2
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “SET”.
- Pan Reverse
This function reverses the Pan movement.
1. Select
“rPAN” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” to enable this function or “OFF” if you don’t.
4. Press [ENTER] or [EXIT/DN] to exit.