elektraLite elektraHazer Haze/fog machine - Manual (Page 3)

• Always make sure there is sufficient fog fluid in the
Tank. Operating this unit without fluid cause
damage to the pump as well as over-heating of the
heater block. Do not leave your elektrafog on for
long periods of time without using it.
• If your Elektralite Fog Machine fails to work
properly, discontinue use immediately. Contact the
dealer you purchased the machine from for after
sales service. If you are required to return the
machine for repair, then drain all fog fluid from the
tank, and pack the unit securely in the original
packing material. Failure to do this could result in
the machine being physically damaged in transit or
fluid being deposited into the machine. Both of which
are not covered by the warranty.
• Always drain tank before shipping this unit.
• Never drink fog fluid. If it is ingested, call a doctor
immediately. If fog liquid comes in contact with skin
or eyes, rinse thoroughly with water. Please keep the
fluid out of reach of children and animals. Mop up any
spills immediately.
Unpacking & Inspection
Open the shipping carton and verify that all equipment
necessary to operate the system has arrived intact. Refer
to the “Features” section for information on what items are
included with your Elektralite fog machine. If any
equipment is missing contact your Elektralite dealer
immediately.
Before beginning initial setup of your Elektralite Fog
Machine, make sure that there is no evident damage caused
3
by transportation. In the event that the unit’s housing or
cable is damaged, do not plug it in and do not attempt to use
it until after contacting your Elektralite dealer for
assistance.
Setup
• Remove all packing materials from shipping box.
Check that all foam and plastic padding is removed,
especially in the nozzle area.
• Place fog machine on a flat surface and remove fog
fluid tank cap.
• Fill with Elektralite Fog liquid. Any other types of
fluid can damage the unit. When filled, place cap
back on liquid tank.
• Firmly attach the remote control cable to the proper
input on the rear of the machine if using the remote
included in the shipment. If using the DMX input
please refer to the DMX section in this manual. The
Elektralite fog machine must have either the remote
plugged in or a DMX signal actively coming to it for
the machine to heat up. No signal then no heater will
be turned on. The power on switch merely provides
the machine with power, it does not initiate the
heater block to heat up without a DMX or remote
signal.
Operation
•
Plug the power cord into a grounded electrical outlet.
Turn the power switch on the rear of the unit to
“ON” position. Warm-up is complete when the green
lamp lights up on remote unit.
4