elektraLite elektraHazer Haze/fog machine - Manual (Page 4)

• To emit fog, press the appropriate button on the
remote for the desired length of time. See Remote
control operation section or DMX section.
• The remote control’s lamp will cycle on and off as the
machine automatically turns on and off the heater to
heat the fluid to within the operational temperature
range of the heater block.
• For further information on operating your Elektralite
Fog Machine, see the section entitled, “Remote
Control Operation”.
Important: Always monitor tank fluid level as you are
fogging. Running a fog machine with no fluid
can
permanently damage the unit.
If you experience low output, pump noise or no output at all,
unplug immediately. Check fluid level, the external fuse,
remote connection, and power from the wall. If all of the
above appears to be O.K., plug the unit in again. If fog does
not come out after holding the remote button down for 15
to 20 seconds, check the hose attached to the tank to make
sure that there is fluid going through the hose. Sometimes
it may be necessary to check the hose to make sure that it
is in the fluid. As the fluid is used up, the hose can come
out of the fluid reservoir. If none of the above resolves
your problems or you are unable to determine the cause of
the problem, do not simply continue pushing the remote
button, as this may damage the machine. Contact your
Elektralite dealer.
5
Remote Control Operation
• If you are using the supplied remote control,plug
the remote into the 4 pin female connector at the
back of the fog machine. Then turn on the machine.
Immediately upon turn on, the center red LED will
come on. Please now wait approximately 5 to 6
minutes for the block to heat up. The right hand side
LED will come on (colored green) when the block has
reached its operating temperature.
• Press the manual button and fog will be emitted from
the front nozzle of the machine. If there is a loud
vibration noise from the fog machine, this is probably
because there is no fluid getting to the pump.
Providing the tubing in the tank is actually in the
fluid, then the pump will pull the fluid through the
pump at which time the pump will stop vibrating. If
this has not occurred within 20 to 30 seconds, then
stop pressing the manual button and check to see if
there are any breaks or blockages in the tubing which
is stopping the fluid from reaching the pump.
• The manual button is a momentary button. If you
release the button the output ceases immediately.
The other two buttons (timers on/off and continuous
fogging) are latch on or off buttons. A single press
turns the button on and a second will turn it off.
• Timers on/off. Yellow button with a corresponding
yellow LED giving an indication of when this button I
son. This button is used as the switch for turning on
the automatic features of the fog machine. It is
6