Ferguson Ariva T650i - Manual (Page 11)

7. Connecting the terrestrial antenna
There are no special antennas for DVB-T. For collection of digital television, the same antennas
as analog TV reception. There is no need to change the antenna system. It is worth to check the
quality and condition of the plant, which has so far been used for analog TV reception.
Reception problems can be weathered with old antenna systems, or grid antennas. It is
recommended to use directional antennas with signal amplifier, depending on the particular
situation you may also establish impedance transformer. Indoor antenna may be used only in
areas with high signal intensity.
8. Connecting the receiver
The following illustrations show cable connections for a television and other devices connected
with the receiver. If you require any assistance in connecting individual devices, contact your
local technician. Before connecting or altering cabling, disconnect the receiver from the
mains !!!
Note: Availability and type of connection depends on your receiver model! Not all of the
connections are applicable for your receiver!
8.1 Connection by means of an HDMI cable (recommended)
1. Connect the antenna to the ANT IN socket of the receiver.
2. Connect the HDMI to the receiver out and the television in.
Connection by means of an HDMI cable allows you to obtain the highest image quality.
If you have an amplifier with an HDMI out and in, which supports sound sent over HDMI,
connect the devices by two HDMI cables. As in the following figure: one cable to the
amplifier, and the other from the amplifier to the television set.
11