Haltech Platinum PRO PLUG-IN Nissan Z32 300ZX (HT055007) User Manual
Page 12
The
Haltech CAN Network
The Haltech CAN network allows for simple and effective expansion in ECU capability
and functionality without having to go to the trouble of wiring in a whole new computer.
Expansion is made possible by the addition of multiple expansion devices that
communicate to the main ECU via a Control Area Network (CAN).
Installation time and costs are kept to a minimum as all expansion devices are
powered up from the main ECU via the pre-terminated connection cable that comes
with each expansion device.
Simply connect the device directly to the 8 pin CAN connector on the rear of the ECU
or connect using an optional Haltech CAN Hub (order as part # HT059990) if multiple
expansion devices are required).
Each expansion device is pre-programmed with a unique ID code which allows it to
be recognised on the network and work correctly first time every time.
For current available expansion devices please go to our website at
Figure 9 – Haltech ECU connected to a Racepak Dash
Figure 10 – Haltech ECU connected to 5 Auxiliary CAN based devices
2. With the ignition turned off remove the 3 x 10mm bolts mounting the ECU to the vehicle.
Proceed to remove the bolt in the centre of the ECU connector using a 10mm socket
and gently ease the connector out. Be sure to pull the connector out squarely so as
not to cause any damage to the pins or wires. With the connector disconnected the
ECU can be removed from the vehicle.
Figure 3 – Mounting Bolt Locations
3.
Remove the 4 screws securing the mounting bracket to the factory ECU.
Attach this bracket to the Haltech ECU as shown in figure 4 below using cable ties
and 3M tape. Re install into vehicle.
Figure 4 – Platinum Pro Plug-in ECU mounted in factory location