HID VertX EVO V2000 Installation Guide - Manual (Page 5)

VertX EVO V2000 Installation Guide, 72000-902, rev A.2
April 2012 Page 5 of 18
© 2003 - 2012 HID Global Corporation. All rights reserved.
Step 1 Connect
1.1 What you need before getting started
Prior to starting the installation, completely read this guide.
Reference the Configuration Check List , page 16, and gather the information before proceeding with these instructions.
CAUTION:
VertX controllers are sensitive to Electrostatic Discharges (ESD). Observe precautions while handling the circuit
board assembly by using proper grounding straps and handling precautions at all times.
To further protect against the harmful effects of EMC and transients, a functional earth connection
point is provided under two of the mounting screws (see silkscreen symbols).
1.2 V2000
Verify the battery jumper is installed in the ON position, P10 connector.
1.3 Mounting Instructions
1. Always mount the V2000 controller in the protected.
2. Battery Installation (see Battery Replacement )
a. Remove the cover.
b. Insert the battery (with the + (positive) side facing
upwards) under the prongs, lowering the opposite side
into place.
3. Mount using the four mounting screws (provided) or other
appropriate fasteners. Place the fasteners in the corner holes
of the base.
4. Position the VertX EVO devices in such a way as to provide
room for wiring, air-flow and cable runs.
5. Replace cover.