AT&T 6200 - Manual (Page 5)

Making a Net2Phone Call
• Press
P,
on the cordless handset to
access your Net2Phone account. Follow the voice
prompts to complete your call.
Changing your Net2Phone Access Number
This phone is pre-programmed to dial 1 866 333-8506
when you press
. If Net2Phone provides you
with a local access number in your area you will need
to reprogram the net2phone button on your cordless
handset.
Note: Following this procedure without dialing new
digits in
Step 3 will erase the Net2Phone memory.
1 Make sure the handset is off.
2 Press g . The PHONE light blinks.
3 Dial the local access number Net2Phone has
provided.
4 Press P five times.
5 Press .
Handset Ringer Style
You can select from four different handset ringer styles.
1 Make sure the handset is off.
2 Press g,
#.
3 Press
1, 2, 3 or 4 to select your ringer style.
You will hear a sample of the ringer style.
4 Press g.
Ringer Off/Battery Save
1 Make sure the handset is off.
2 Press g, #.
3 Press
5.
4 Press g.
5 To turn the ringer on again, see Handset Ringer Style.
TELEPHONE OPERATION
Headset Jack
You can use this telephone hands-free when you install
any AT&T 2.5 mm headset, purchased separately.
Plug the headset into the jack located on the right side
of the handset (under the small rubber flap). Do not force
the connection, but make sure the plug fits securely.
Operating Range
This cordless telephone operates within the maximum
power allowed by the Federal Communications
Commission (FCC). Even so, this handset and base can
communicate over only a certain distance — which can
vary with the locations of the base and handset, the
weather, and the construction of your home or office.
For best performance, keep the base antenna fully
upright.
If you receive a call while you are out of range, the
handset might not ring — or if it does ring, the call might
not connect when you press
P. Move closer to the
base, then press
P to answer the call.
If you move out of range during a phone
conversation, you might hear noise or interference.
To improve reception, move closer to the base.
If you move out of range without pressing
P,
your phone will be left “off the hook.” To hang up
properly, walk back into range, periodically pressing
P.
5