AT&T 1445 - Manual (Page 6)

9
Getting Started
8
Getting Started
Belt clip & optional headset
Install belt clip as shown below if desired.
For hands-free telephone conversations, you can use any industry standard 2.5 mm
headset (purchased separately). For best results use an AT&T 2.5 mm headset.
Wall mounting
The telephone base can be installed on any standard wall-phone outlet as shown below.
Choose a location away from electronic equipment, such as personal computers,
television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Plug power cord
transformer into
electrical outlet
Press and slide down firmly so
base is held securely on outlet
mounting pegs
Plug short line cord
into telephone jack
Connect line cord and AC adapter as
shown on page 6, then press notch and
pull to open hinged wall mount
Swivel wall mount down
and lock in place
Snap belt clip into notches on
side of handset. Rotate and pull
to remove.
Plug 2.5 mm headset
into jack on side of
handset (beneath
small rubber cap)