4 print top of form – HID FARGO HDP5000 User Guide User Manual
Page 25
July 2013
Page 25 of 100
© 2012, 2013 HID Global Corporation. All rights reserved.
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
4.7.4 Print Top of Form
From
Advanced Settings, modify the Print Top of Form Setting.
Figure 5 - Print Top of Form
Step
Procedure
1
Verify the Transfer TOF is set to +35.
2
Verify the Print TOF is set to +20.
3
Verify the Print LOF is set to +7.
4
Print the alignment card self-test (the front edge should look like the figure).
5
Adjust the Print TOF until the green border is eliminated and the entire Transfer Alignment Block is
shown in the center of the card.
Note:
Due to variation in roller alignment, the green border may appear at a slight angle on the top of
the card.
6
Verify the entire alignment block is visible and the green has been eliminated from the center of the
card.