Karcher MV 3 P - Manual (Page 17)

– 10
 For vacuuming up moisture or wet-
ness pay attention to the correct
floor nozzle insert and connect the
corresponding accessories.
ṇ Caution:
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.
Illustration
 Adapt the adapter to the connection
diameter of the electric tool using a
knife if necessary.
 Connect the adapter to the handle
of the suction hose and connect it to
the electric tool connection.
Connect the mains plug of the elec-
tric power tool to the vacuum clean-
er.
Illustration
 Switch the vacuum cleaner to Posi-
tion II and start working.
Note: As soon as the electric tool is
switched on, the suction turbine starts
with a 0.5 second delay. If the electric
tool is switched off, the suction turbine
continues to run for approx. 5 seconds
in order to vacuum up the remaining
dirt in the suction hose.
Cleaning hard to reach locations or,
where vacuuming is not possible, like
leaves from a gravel bed.
Illustration
 Connect the suction hose to the
blower connection, this will activate
the blower function.
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the park-
ing position.
 Turn off the appliance and discon-
nect the mains plug.
Illustration
 Remove the appliance head and
empty the reservoir.
Illustration
 Stow away the mains cable and ac-
cessory at the machine. Store the
appliance in a dry room.
Wet vacuum cleaning
Working with electrical power
tools
Blowing function
Interrupting operation
Finish operation
Empty the container
Storing the appliance
17 EN