Karcher VC 6300 - Manual (Page 13)

– 3
Illustration

Connect handle and suction tube and
insert.
 Connect the floor nozzle and telescopic
suction pipe and insert.
Illustration

Use the adjustment in order to adjust
the telescopic suction pipe to the length
you wish.
Illustration

When you stop or you take a short
break, hang the floor nozzle into the
parking position on the back of the ap-
pliance, and push it into the resting po-
sition.
Illustration

To remove, press handle backwards in
the direction of the appliance. The floor
nozzle is thus unlocked from the parking
holder and can be removed upwards.
Illustration

Hold the power cord at the plug and pull
it out. Insert the mains plug into a socket.
 Turn on/off the appliance.
Illustration

The power suction adjustment is at the
power suction control:
+ push button (A), higher power suction
- push button (B), lower suction power
Adjust the suction power to suit the suc-
tion requirement:

Low suction power – for laced cur-
tains, textiles, upholstered furniture,
cushions
 Medium suction power – for slightly
dirty carpets/ carpeted floors, precious
carpets, bridges and runners
 Highest suction power – for hard
floors, very dirty carpets and carpeted
floors
 It is advisable to use the Stand-by key
(C) during short breaks in cleaning:
Press the Standby key, the appliance
switches off, the LED on the appliance
glows to indicate the standby mode.
 Press the Stand-by key again to
resume work.
Note: After pressing the stand-by key,
the vacuum cleaner runs at the vacuum
setting that had been set earlier.
Important notice! The appliance will shut-
down automatically, if there is danger of
overheating. Turn the appliance off and pull
the power plug. Make sure, that the nozzle,
the suction pipe or the tube is not clogged,
failing all the above the filter must be
changed. After the elimination of the inter-
ference let the appliance cool down for a
minimum of 1 hour, before using it again.
 Upholstery nozzle: for cleaning uphol-
stered furniture, mattresses, laced cur-
tains, etc.
 Furniture brush, rotating: for cleaning
furniture and delicate objects with care,
dusting books, air vents in the car, etc.
 Joint nozzle, detachable: for edges,
joints and heaters
 Hang in the floor nozzle in the park
holder on the rear side of the machine
and press it into locking position (see il-
lustration 4)
Illustration

Push the dead button at the handle and
remove the telescopic suction pipe.
Illustration

Open the attachment housing cover.
Illustration

Insert the handle in the desired acces-
sory until the stop. It then gets locked.
Then tilt it downwards and pull it out.
Illustration

To store, put the attachment using the
handle into the attachment housing and
click it up into place. Remove the handle.
 Notice: You also can remove the at-
tachment manually and put it on top of
the handle. In order to release the at-
Suction using accessories
QuickClick attachment
QuickClick Using the attachments
Changing the attachments in the Quick-
Click attachment housing
13 EN