Karcher VC 6300 - Manual (Page 14)

– 4
tachment, push the dead button on the
handle.
 Notice: All steps stated above can also
be done when the telescopic suction
pipe is connected. Hang the floor noz-
zle on the backside of the appliance into
the parking holder, and push into the
pause position. Pull the telescopic suc-
tion pipe straight up.
Illustration

Carpets and carpeted floors:
Select the following switch setting:
Illustration

Hard surfaces:
Select the following switch setting:
 Turn off the appliance and disconnect
the mains plug.
Illustration

Push the take-up cable button. The ca-
ble will pull itself automatically into the
appliance.
 Hang the floor nozzle on the backside
of the appliance into the parking holder,
and push into the pause position.
 Hold the appliance at the carrying han-
dle when you want to transport it and
store it in dry rooms.
Note: It is recommended that you first
completely push in the telescopic suc-
tion pipe.
ƽ
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
ṇ
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.

Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
 Clean the dust chamber with a dry wipe
cloth/ dust brush.
Order no. 6.904-329
Contents: 5 filter bags with cap and 1 en-
gine protection filter.
Note: Separate the telescopic suction pipe
from the handle to see the filter change in-
dicator.
Illustration

If the filter change indicator in the cover
glows red, then please change the filter
bag.
 Use the closing lever and open the lid.
Illustration

Unlock the holder of the filter bags and
pull towards the outside.
Illustration

Close the filter bag using the closing flap,
remove the filter bag and dispose it off.
Illustration

Push the new filter bag into the support
until the stop. First press the flap down-
wards; then push the holder into the cas-
ing and lock it at the appliance casing.
ṇ
Caution
Close the lid only, if there is a filter bag in-
serted. After picking up small dust particle
(as for example plaster, cement etc) clean
the motor protection filter, change if neces-
sary.
ComfoGlide nozzle
Finish operation
Transport, storage
Maintenance and care
Cleaning the device
Replacing the filter bag
14 EN