Karcher SE 4002 - Manual (Page 15)

– 8
Illustration

Turn the motor casing around and at-
tach the foam filter to the filter basket.
 Insert the filter cover and turn to lock.
 Install the motor casing. Pull up on
the carrying handle to lock.
Illustration

Install the fresh water reservoir. In-
sert the bottom part first and then press
toward the top on the motor compart-
ment to check if it is locked in.
Illustration

Attach the suction hose and the spray
hose to the connectors on the appli-
ance.
Note
: Press the suction hose tightly into the
connector to lock it into place.
Illustration

Connect the spray/suction pipes and at-
tach to the handle. Center the locking
lever when attaching it, turn clockwise
to lock.
 Attach the floor nozzle to the spray/suc-
tion pipes and secure with locking lever.
The appliance is now prepared for wet
cleaning.
Caution
Always work with an inserted foam filter
- during wet as well as dry vacuum
cleaning!
Caution
Check the object to be cleaned prior to us-
ing the appliance in an inconspicuous place
for colour fastness and water resistance.
Do not clean water-sensitive floor cover-
ings such as wood floors (the moisture
could penetrate and damage the floor).
Note
Warm water (max. 50°C) will increase the
cleaning effect.
 Use the wash floor nozzle.
 Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
 Use the wash floor nozzle.
 Slide the attachment for hard surfaces
onto the spray ex floor nozzle from the
side. The bristles should point towards
the back.
 Use the wash hand nozzle.
Note: You can remove the water reservoir
to fill it or you can fill it directly on the appli-
ance.
Illustration

Flip the reservoir cover up.
 Add 100 - 200 ml (volume depends on
degree of contamination) of RM 519
into the fresh water reservoir, then add
tap water - do not overfill.
 Close the reservoir cover.
Illustration

Insert the mains plug into the socket.
 Press the switch for suction (position I),
suction turbine is running.
Illustration

Close fully the surrounding air separa-
tor at the handle.
Illustration

Press the switch for spraying (position
I), the detergent pump is ready.
Illustration

Use the lever on the spray handle to
spray on detergent solution.
Illustration

For continuous spray, the spray lever
can be locked; for this, activate the
spray lever and pull the locking key to-
ward the rear.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
Operations
Wet cleaning of carpets/hard
surfaces/upholstery
Wet cleaning of carpeted floors
Wet cleaning of hard surfaces
Wet cleaning of upholstery
Fill up fresh water reservoir
Start working
15 EN