Karcher SE 6-100 - Manual (Page 17)

– 10
Vacuuming hard surfaces
Illustration

Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are extended.
Vacuuming carpeted floors
Illustration

Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are retracted.
 Use the surrounding air separator to
adapt the suction force.
Note:
Close the surrounding air separator
again after use!
ṇ
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!

Remove the fresh and wastewater con-
tainers, vacuum the wet dirt directly into
the container.
 Use wash nozzles to vacuum moisture
or wetness.
 Once the wastewater container is full,
the appliance switches off automatical-
ly.
Note: Once the appliance shuts off,
switch it off using the vacuum button,
because the suction turbine will other-
wise start running again once you open
the appliance.
If you use a crevice nozzle:

Attach and secure the adapter for wet/
dry vacuuming. Install the crevice noz-
zle directly to the adapter.
 Switch on the vacuum process.
Illustration

During interruptions in operation, the
suction pipe can be simply clipped into
the accessories storage and removed
again.
 Turn off the appliance.
 Drain the full container.
 Rinse the reservoir thoroughly with
clear water.
 Separate the handle, the spray/suction
hoses and the wash nozzle from each
other; open locking lever to achieve this
(centre position),
 Flush the accessories separately under
running water and let air dry.
 Leave the appliance open to let it dry.
Illustration

Accessories storage: Suction hose,
suction pipes and accessories can be
comfortably stored on the appliance.
 Storing the appliance. Store the appli-
ance in a dry room.
ƽ
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorised customer service.
ṇ
Warning
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
With an uneven spray jet.
Illustration

Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
1 x year or as needed.
Illustration

Clean sieve.
Wet vacuum cleaning
Interrupting operation
Finish operation
Maintenance and care
Clean the spray nozzle
Clean the sieve in the fresh water
reservoir
17 EN