Karcher SC 3-100 B - Manual (Page 20)

– 11
 Illustration
Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
 Illustration
During work breaks, hook the floor noz-
zle into the parking holder.
Application:
– Windows, mirrors
– Glass surfaces on showers
– other smooth surfaces
 Perform a fat dissolving basic cleaning
using the hand nozzle and a terry cloth
cover before using the window wiper.
 Apply steam to the glass surface from a
distance of approximately 20 cm until
the surface is moistened evenly.
 Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip of the window wiper. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
ƽ
Danger
 The steam pressure iron must not be
used if it has been dropped, shows vis-
ible signs of damage or if it leaks.
 The steam pressure iron is hot and
so is the steam jet! Point out to other
people the possible risk of being scald-
ed or burnt. Never direct the steam jet at
people or animals (risk of scalding). Do
not touch any electrical leads or com-
bustible objects with the hot steam
pressure iron.
ṇ
Warning
 The steam pressure iron and its con-
necting cable must be kept out of reach
of children under the age of 8 during the
heating and cooling down periods.
 The steam pressure iron must be used
and placed on a stabile surface.
Note: We recommend using the Kärcher
ironing table with active steam extraction
(2.884-933.0). This ironing table has been
designed to match your new steam clean-
er. It facilitates and, thus, accelerates the
ironing process substantially. In any case,
you should use an ironing table which is
covered with a mesh-type underlay allow-
ing the steam to pass through.

Tightly insert the steam plug of the iron
into the appliance connector. The plug
must click into place audibly.
 Make sure that there is fresh tap water
in the boiler of the steam cleaner.
 Start-up the steam cleaner according to
the description.
 Wait until the steam cleaner is ready to
use.
All fabrics can be steam ironed. Delicate
imprints or fabrics should be ironed on the
reverse or according to the manufacturer’s
specifications.
Note: For these sensitive textiles, we rec-
ommend using the KÄRCHER non-stick
ironing sole BE 6006 (Ordner no. 2.860-
142.0).

Adjust the temperature control of the
steam iron within the notched range
(•••/MAX).
 As soon as the indicator lamp of the
heater of the iron switches off, you can
start ironing.
Note: The sole plate must be hot to pre-
vent the steam from condensing on the
sole plate and dripping onto the gar-
ment to be ironed.
 Use the top or bottom steam switch.
– Steaming at intervals: Press the
steam switch. Steam will be emitted
while the switch is pressed.
Parking the floor nozzle
Window wiper
Steam iron
Steam ironing
20 EN