AMS Neve 4081 - Manual (Page 8)

4081 User Manual Issue 2
For this switch, it is On when in the up position.
> Remove the lid to the unit, and set the 1 st (left-most) switch on this
block to be ON, then set the switches on the rear of the unit to the
following:
Unit ID Switch 1 Switch 2 Switch 3
9 Off Off Off
10 On Off Off
11 Off On Off
12 On On Off
13 Off Off On
14 On Off On
15 Off On On
16 On On On
If a unit's ID is changed, the power must be switched off and on again for
the remote control software to receive the new ID number.
If the unit IDs are set incorrectly, they will either fail to respond or
multiple units will respond to a single command.
Technical Earth
When switched on, internally connects zero volts to the unit chassis.
- 8 -
This block of switches may
be covered with a thin
protective film, which will
need to be carefully removed
before attempting to set the
switches.