Acnodes PCH 5120 - Manual (Page 54)

14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
PCH 5120
12.1” industrial Panel PC
IP67 rated fully enclosure
Normally if this option is not enabled, any attached USB mouse or USB keyboard does not become avail-
able until a USB compatible operating system is fully booted with all USB drivers loaded. When this option
is enabled, any attached USB mouse or USB keyboard can control the system even when there is no USB
driver loaded onto the system.
Disabled Legacy USB support disabled
Enabled DEFAULT Legacy USB support enabled
Auto Legacy USB support disabled if no USB devices are connected
ƒ USB2.0 Controller Mode [HiSpeed]
Use the USB2.0 Controller Mode option to set the speed of the USB2.0 controller.
FullSpeed The controller is capable of operating at 12 Mb/s
HiSpeed DEFAULT The controller is capable of operating at 480 Mb/s
5.3.7.1 USB MASS STORAGE DEVICE CONFIGURATION
Use the USB Mass Storage Device Configuration menu (BIOS Menu 13) to configure USB mass storage
class devices.
ƒ USB Mass Storage Reset Delay [20 Sec]
Use the USB Mass Storage Reset Delay option to set the number of seconds POST waits for the USB
mass storage device after the start unit command.