Sony NVX-HC1 - Manual (Page 10)

10
01GB02CD-EUR.fm
NVX-HC1
2-583-235-11 (1)
masterpage:Left
Receiving GPS signals
When using the navigation system for the first
time after installing, drive your car on the roads
without high buildings around for 30 minutes at a
regular speed. The system requires signals from
minimum 3 GPS satellites to calculate the
current car position properly.
Notes on current car position
• Before operating the system for the first time, or after
replacing the car battery, your current car position on
the road map will be the default (Greenwich,
London, UK) until GPS signal becomes receivable.
• The current car position on the map may be widely
off the road until the speed pulse from your car is
properly checked.
Registering your home
It is highly recommended to register your home
in memory for easy recall next time.
1
Park your car at the point where you
want to register as home.
2
Press (MARK) .
The confirmation display appears.
3
Select “Yes” by pressing < or , ,
then press (ENTER) .
The address of the current car position is
stored in memory.
4
Press (MENU) .
5
Select “Navigation Setup” by pressing
< or , , then press (ENTER) .
6
Select “Memory Points” by pressing M
or m , then press (ENTER) .
The address list appears.
7
Select the address stored in step 2 by
pressing
M or m , then press (ENTER) .
8
Select “Register as Home” by
pressing
M or m , then press (ENTER) .
The conformation display appears.
9
Select “Yes” by pressing < or , ,
then press (ENTER) .
The current car position is registered as home.
Setting the clock
automatically
You can adjust the clock based on the GPS
information.
1
Press (NAVI) to select the audio mode.
2
Press (MENU) .
3
Select “Setup” by pressing < or , ,
then press (ENTER) .
4
Select “GPS” by pressing < or , ,
then press (ENTER) .
5
Press (ENTER) to select the desired
item.
6
Press (MENU) .
The display returns to the audio display.
Note
There might be a difference between the time set by
the GPS information and the actual time.
Tip
The system supports the summer time.
GPS reception sensitivity shows the number of
GPS satellites currently identified.
Make sure at least 3 increments are indicated.
Items:
“AUTO” sets the local time of the current
position.
“HOME” sets the local time of stored home
position.
“OFF” cancels setting time automatically.