Sony MEX-BT2900 - Manual (Page 23)

23
*1 When the unit is turned off.
*2 When FM is received.
*3 When the audio output is set to “SUB-OUT.”
Using optional equipment
Auxiliary audio equipment
By connecting an optional portable audio device
to the AUX input jack (stereo mini jack) on the
unit and then simply selecting the source, you
can listen on your car speakers. The volume level
is adjustable for any difference between the unit
and the portable audio device. Follow the
procedure below:
Connecting the portable audio
device
1 Turn off the portable audio device.
2 Turn down the volume on the unit.
3 Connect to the unit.
* Be sure to use a straight type plug.
Adjusting the volume level
Be sure to adjust the volume for each connected
audio device before playback.
1 Turn down the volume on the unit.
2 Press (SOURCE/OFF) repeatedly until “AUX”
appears.
After that, “AUX FRONT IN” appears.
3 Start playback of the portable audio device at a
moderate volume.
4 Set your usual listening volume on the unit.
5 Adjust the input level (page 22).
BEEP
Activates the beep sound: “ON,” “OFF.”
AUX-A* 1 (AUX Audio)
Activates the AUX source display: “ON,”
“OFF” (page 23).
AUTO OFF
Shuts off automatically after a desired time
when the unit is turned off: “NO,” “30S
(Seconds),” “30M (Minutes),” “60M (Minutes).”
REAR/SUB* 1
Switches the audio output: “SUB-OUT”
(subwoofer), “REAR-OUT” (power amplifier).
DEMO (Demonstration)
Activates the demonstration: “ON,” “OFF.”
DIMMER
Changes the display brightness: “ON,” “OFF.”
AUTO SCR (Auto Scroll)
Scrolls long items automatically: “ON,” “OFF.”
LOCAL (Local Seek Mode)
– “ON”: to only tune into stations with stronger
signals.
– “OFF”: to tune normal reception.
MONO* 2 (Monaural Mode)
Selects monaural reception mode to improve
poor FM reception: “ON,” “OFF.”
REGIONAL* 2
Restricts reception to a specific region: “ON,”
“OFF” (page 15).
LPF* 3 (Low Pass Filter)
Selects the subwoofer cut-off frequency: “OFF,”
“80Hz,” “100Hz,” “120Hz,” “140Hz,” “160Hz.”
SW PHASE* 3 (Subwoofer Phase)
Selects the subwoofer phase: “NORM,” “REV.”
HPF (High Pass Filter)
Selects the front/rear speaker cut-off frequency:
“OFF,” “80Hz,” “100Hz,” “120Hz,” “140Hz,”
“160Hz.”
LOUDNESS
Reinforces bass and treble for clear sound at low
volume levels: “ON,” “OFF.”
BTM (page 14)
AUTO ANS* 1 (Auto Answer)
Answers an incoming call automatically.
– “OFF”: to not answer automatically until
(handsfree) is pressed.
– “1”: to answer automatically after 3 seconds.
– “2”: to answer automatically after 10 seconds.
RINGTONE* 1
Uses the ringtone of this unit or the connected
cellular phone: “1 (this unit),” “2 (cellular
phone).”
BT INIT* 1 (Bluetooth Initialize) (page 21)
Connecting cord*
(not supplied)