ADS Technologies Wireless Cable Modem Gateway SBG1000 - Manual (Page 26)

20 SBG1000 User Guide
Home
X
Exit Print
Overview Installation Troubleshooting Contact FAQ Specifications Glossary License
Configuration: Basic Gateway TCP/IP Wireless Print Server USB
Installation
The following subsections provide information about installing the SBG1000 hardware:
•
Before You Begin
•
Precautions
•
Signing Up for Service
•
Computer System Requirements
•
Connecting the SBG1000 to the Cable System
•
Cabling the LAN
•
Obtaining an IP Address for Ethernet
•
Connecting a PC to the USB Port
•
Connecting the Printer
•
Wall Mounting
•
Installing the Optional External Diversity Antenna
For information about wireless LAN setup, see “ Setting Up the Wireless LAN ”.
Before You Begin
Before you begin the installation, check that you received the following items with your SBG1000:
You will need 75-ohm coaxial cable with F-type connectors to connect the SBG1000 to the nearest cable outlet. If
a TV is connected to the cable outlet, you may need a 5 to 900 MHz RF splitter and two additional coaxial cables
to use both the TV and the SBG1000.
Item Description
Power cord Connects the SBG1000 to the AC electrical outlet
10/100Base-T
Ethernet cable Connects to the Ethernet port
USB cable Connects to the USB port
Phone wire jumper with
RJ-11 connectors Connects to a telephone line used for the HPNA network
SBG1000 Installation
CD-ROM Contains this User Guide and USB drivers