Ariens SNO-THRO 932102 - 520 - Manual (Page 12)

GB - 12
Discharge Chute (932102)
1. Grease discharge chute ring if not already
greased (Figure 4b).
2. Remove mounting hardware from top of
engine.
3. Slide discharge chute over opening on
housing and under the retaining clip.
4. Secure chute support bracket to studs on
top of engine with mounting hardware just
removed.
NOTE: Be sure the discharge chute sits flush
on the discharge chute ring before tightening.
Check Attachment Clutch Cable
1. Ensure spring is connected into hole in
clutch arm at rear of frame.
2. Ensure clutch cable is routed over the top
of the lower handlebar.
932103, 310
Figure 4a
OS2090
1. Mounting Hardware
2. Spring Clip
3. Chute Support Bracket
4. Discharge Chute
5. Discharge Chute Ring
6. Retaining Clip
7. Belt Cover
8. Chute Crank
9. Chute Crank Support
1
2
3
4
5
6
7
8
9
1. Mounting Hardware
2. Discharge Chute
3. Discharge Chute Ring
4. Retaining Clip
5. Belt Cover
6. Chute Support Bracket
1
2
4
3
OS1921
5
932102
6
Figure 4b