Ariens SNO-THRO 932102 - 520 - Manual (Page 17)

GB - 17
To ensure adequate lubricant level:
1. Remove filler plug (Figure 5). Lubricant
must be at least up to bottom of lubricant
filler hole with unit resting on a level
surface.
2. Add lubricant if required. Allow oil to drain
to level of plug and replace plug.
IMPORTANT: Use only Ariens special gear
lubricant L-2 (Part Number 00008000).
GENERAL LUBRICATION
IMPORTANT: Wipe each fitting clean before
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to
get on belts.
NOTE: Apply Sten Mix Hi-Temp Grease or
equivalent to the lubrication fittings.
Sno-Thro should be lubricated at beginning of
season or every 25 operating hours (Figure 6).
Auger Shaft
To grease auger shaft, remove shear bolt nuts
and shear bolts. Turn auger on shaft while
applying grease at zerk fittings. Replace shear
bolts.
Auger Gearcase
Filler Plug
OS1871
Figure 5
OS1843
Grease
Oil
Figure 6