Sony KZ-32TS1E - Manual (Page 5)

5 Safety Information
GB
Additional Safety Information
Checking the Accessories Supplied
• This set should only be moved by two or more people. If the set needs to be transported, it should
be protected to insure that it is not subject to shock, vibration or excessive force.
• The slots and openings in the cabinet and in the back and bottom are provided for the necessary
ventilation. To ensure reliable operation of the set, and to protect it from overheating, these slots and
openings must never be blocked or covered.
• After transporting the set directly from a cold to a warm location, or if the room temperature has
changed suddenly, pictures may be blurred or show poor colour over portions of the picture. This is
because moisture has condensed on the mirrors or lenses inside the set. Let the moisture evaporate
before using the set.
• To obtain a clear picture, do not expose the screen to direct illumination or direct sunlight. If possible,
use spot lighting directed down from the ceiling.
• The screen of this set has an anti-reflection screen coating. To avoid screen degradation, follow the
points mentioned below.
— To remove dust from the screen surface, wipe with the supplied cleaning cloth or a soft cloth.
— Clean the screen and cabinet with a soft dampened cloth. Do not use any abrasive cleaners. As a
safety precaution, unplug the set before cleaning it.
— Avoid touching the screen, and take care not to scratch the surface with hard objects.
• The TV set is not disconnected from the mains when the switch is in Off position. To disconnect
completely the set, pull the plug from the mains.
• Note on use in highlands:
When used at an altitude of greater than 1900m or 6248 feet (air pressure less than 800hPa), this
Plasma Display Panel may generate a low buzzing sound as a result of the difference between the
interior and exterior air pressure of the panels. This is not considered a defect and is not covered by
the Sony Warranty. This buzzing sound is an inherent characteristic of any Plasma display Panel.
Corrosion
Use of this set near the seashore may subject the set to excessive salt, corrosion and internal damage and
result in deterioration of the set’s performance. If the set will be subjected to any of these conditions,
steps should be taken to reduce the humidity and temperature of the area where the set is located.
Image
• An "image ghosting", or "screen burn" may appear on the screen if the television is left operating with,
either a still image, constant 4:3 video pictures in the Normal Display Mode or a programme
displaying a bright corner channel logo, for an extended period of time.
The risk of this is higher if the set is in "Live" mode or has a high contrast setting. This image cannot
be removed once burnt onto the screen. To avoid the risk of occurrence do not leave the television
operating on such a picture, or programme for a long time, use the picture orbiting function or lower
the contrast setting. Repeated extended daily usage of the same image, or programme can also result
in this occurrence. IMAGE RETENTION IS NOT COVERED BY THE SONY WARRANTY.
• With extensive use of the Plasma TV in 4:3 mode, the 4:3 screen are might become darker in case full
16:9 panel is used. To avoid this problem, the “Smart” picture mode should be used.
One Remote Control
(RM-932):
Two batteries (R6 Type): Two Brackets:
One coaxial cable :
Do not remove ferrite cores.
One Cleaning cloth:
One AC Cable (Type C):
Do not remove ferrite cores.
Use this AC cable (with safety
earth) if you use the set outside
the United Kingdom.
One AC Cable (Type BF):
Do not remove ferrite cores.
• Use this AC cable (with
safety earth) if you use the
set in the United Kingdom.
• See “ NOTICE FOR
CUSTOMERS IN THE
UNITED KINGDOM ” on
page 2 when using the cable.
• This cable may not be
supplied depending on the
country.