Sony VPCCW Series Optical Disk Drive (Replacement Instructions) - Manual (Page 2)

VPCCW Series Optical Disk Drive
Replacement Instructions
P/N 989200671 Rev. A 2/3
(Look for the screw hole with 3 dots)
Step 4. Using the enclosed magnetic
screwdriver, remove the (2) screws
securing the optical drive. Step 5. To initiate the removal of the
optical drive, slightly pull the optical
drive door as shown in the picture.
Slight force may be needed to
disconnect drive from connector. Step 6. With even force carefully
remove the optical drive by pulling it
away from the unit.
Step 7. Carefully remove the ODD
assembly.
Step 8. After the ODD is completely
removed, identify the (4) side screws
that mount the ODD brackets to the
ODD.
Step 9. Firmly but carefully hold the
ODD. Remove the screws & brackets
and set them aside. The screws &
brackets will be used on the new
ODD provided.
Note! Identify tabs on the bezel and
tab holes located on the ODD.
Step 10. Bracket & screws should now
be removed. Please arrange the
bracket & screws as shown above. Set
old ODD aside.
Step 11. Take the new ODD and bezel
provided in the CRU kit and prepare for
assembly.
(ODD Disassembly) Steps 8-10
(ODD assembly) Steps 11-14