Sony SLV-N70 - Manual (Page 70)

70 Recording TV programs using the Dial Timer
To return to the previous step
To return to the previous step, press the CHANNEL + and – buttons on the VCR at
the same time during any of the Dial Timer settings.
To stop recording
To stop the VCR while recording, press x STOP.
To use the VCR after setting the timer
To use the VCR before a timer recording begins, just press ?/1. The indicator
disappears from the display window and the VCR switches on. Remember to press
?/1 to reset the VCR to the timer recording standby mode after using the VCR.
You can also do the following tasks while the VCR is recording:
• Reset the counter (page 63).
• Display tape information on the TV screen (page 66).
• Check the timer settings (page 82).
• Watch another TV program (page 67).
7 Press DIAL TIMER.
The channel number or station ID (SLV-N80 only) appears in the display
window.
8 Turn DIAL TIMER to set the channel number.
To record from a source connected to the LINE-1 IN or LINE-2 IN jacks,
turn DIAL TIMER or press INPUT SELECT to display “L1” or “L2”.
If the CABLE BOX CONTROL setting is ON, you can change the channel
number in units of 100 by pressing the CHANNEL +/– buttons (SLV-N80
only).
9 Press DIAL TIMER to complete the setting.
“OK” appears in the display window for about five seconds.
The indicator appears in the display window and the VCR stands by for
recording. When using a cable box, leave it on.
DIAL TIMER
EP
VIDEO APC
DIAL TIMER
INPUT
SELECT
EP
VIDEO APC
DIAL TIMER