Sony VGN-FZxx Series Hard Disk Drive (Replacement Instructions) - Manual (Page 2)

VGN-FZxx Series Hard Disk Drive
Replacement Instructions
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994654600 Rev. B 2/2
Step 4. Using the enclosed magnetic
screwdriver, loosen the one screw
securing the hard disk drive access
cover. Step 5. To remove the HDD access
cover, start by lifting from the side where
the screw held it in place. Step 6. Using the enclosed magnetic
screwdriver, remove the three (3)
screws securing the HDD assembly.
Step 7. Carefully pull the clear plastic
tab towards you to detach the HDD
from the connector.
(HDD Reinstallation) Steps 8-11
Step 8. Replace the old HDD assembly
with the new one. Hold the HDD on the
sides to avoid damaging the part.
Step 9. Attach the HDD assembly to
the HDD connector. Make sure the
screw holes are aligned correctly.
Step 12. Reinstall the battery pack and
reconnect the AC Adaptor.
Power on your computer and continue
with the recovery process by following
the instructions described on the back
of the recovery disk’s case.
Return the old HDD to Sony following
the included shipping instructions.
Step 10. Re-install the three (3) screws
securing the HDD assembly in place. Step 11. Re-install the HDD cover.
Lift To Remove