Sony DSC-P8 User Manual

Page 88

Advertising
background image

88

Shooting still images/movies

The battery remaining
indicator is incorrect, or
sufficient battery
remaining indicator is
displayed but the power
runs out soon.

• You have used the camera for a long time in an

extremely hot or an extremely cold location.

• A deviation has occurred in the remaining

battery time.

• The battery pack is discharged.
• The battery pack is dead (page 110).

p Fully discharge and then charge the battery pack so that the

battery remaining indicator functions correctly (page 11).

p Install a charged battery pack (page 10).
p Replace the battery pack with a new one.

The battery pack runs
down too quickly.

• You are shooting/viewing images in an

extremely cold location.

• The DC plug is dirty so the battery pack is not

charged enough.

• The battery pack is dead (page 110).

p Clean the pins of the AC Adaptor with a cotton swab, etc., and

charge the battery pack (page 10).

p Replace the battery pack with a new one.

You cannot turn on the
camera.

• The battery pack is not installed correctly.
• The AC Adaptor is disconnected.
• The battery pack is discharged.
• The battery pack is dead (page 110).

p Install the battery pack correctly (page 10).
p Properly connect the AC Adaptor (page 13).
p Install a charged battery pack (page 10).
p Replace the battery pack with a new one.

The power turns off
suddenly.

• If you do not operate the camera for about 90

seconds while the power is on, the camera turns
off automatically to prevent wearing down the
battery pack (when [Power Save] is [Off] after
three minutes) (page 14).

• The battery pack is discharged.

p Turn on the camera again (page 14) or use the AC Adaptor

(page 13).

p Install a charged battery pack (page 10).

Symptom

Cause

Solution

The LCD screen is not
turned on even when the
power is turned on.

• The power was turned off with the LCD screen

turned off the last time you used the camera.

p Turn on the LCD screen (page 28).

The subject is not visible
on the LCD screen.

• The mode dial is set to

or SET UP.

p Set it to other modes (pages 21 and 68).

Symptom

Cause

Solution

Advertising
This manual is related to the following products: