Sony KDL-46V25L1 - Manual (Page 6)

6
(GB)
SU-WL51
2-652-380-11(1)
Step 2:
Deciding on the
installation location
1
Referring to the TV or monitor
installing dimensions table on
page 12 and placing the supplied
paper template on a perpendicular
and flat wall, decide on the
installation location.
Allow for suitable clearance between the TV or
monitor and the ceiling and protruding parts of the wall
as shown below.
Note
If you intend to route the cables in the wall, make a
hole in the wall to insert the cables. The position for the
cable hole is shown in the diagram on page 13.
2
Referring to the diagram on page
13, determine the positions of
the screws for installing the plate
unit.
If you intend to route the cables
in the wall, also determine the
position of the cable hole and
bore a hole in the wall.
Unit: mm (inches)
100
(4)
100
(4)
100 (4)
30
0
(11
7
/ 8
)
WARNING
The wall that the TV or monitor will be installed on
should be able to support a weight of at least four
times that of the TV or monitor (page 12).
Make sure of the strength of the wall the TV or
monitor will be installed on. Reinforce the wall
sufficiently, if necessary.
Step 3:
Installing the Plate Unit
on the wall
1
Secure the Plate Unit to the wall
using four or more M8 or
equivalent screws (not supplied).
Select at least four screw holes with the same mark
shown in the diagram below, and tighten the screws
securely so that they will not become loose.
Align the unit so that it is exactly level.
Plate Unit
WARNING
• The screws used in this procedure are not
supplied.
• Select screws suitable for the material and the
structure of the wall.
• If the Plate Unit cannot be attached securely
enough, use additional screws.
• Be sure to confirm that the Plate Unit is securely
attached to the wall.
01GB01COV.book Page 6 Tuesday, December 20, 2005 4:59 PM