Sony KDL-46SL140 - Manual (Page 42)

42
No color/Dark picture/Color is
not correct/The picture is too
bright.
❑
Press to select the desired picture mode (page 21).
❑
Adjust the Picture Mode options in the Picture menu (page 30).
Noisy picture.
❑ Make sure that the antenna is connected using a 75-ohm coaxial cable (not
supplied).
❑ Keep the antenna cable away from other connecting cords.
❑ To avoid TV interference, make sure to use an undamaged antenna cable.
Blurry picture/Poor color.
❑ Transporting the TV from a cold to a warm location or a sudden change in
room temperature may cause moisture condensation, resulting in a blurry
picture or poor color. Turn off your TV and wait a few hours before
powering on again.
No sound/Noisy sound
Good picture, no sound.
❑ Check the volume control.
❑ Press
or VOL + so that “Muting” disappears from the screen (page 22).
❑ Set Speakers to On in the Sound menu (page 31). If it is set to Off,
sound is not output from the TV’s speakers regardless of the TV’s volume
control.
❑ When using HDMI input with Super Audio CD or DVD-Audio, DIGITAL
AUDIO OUT (OPTICAL) may not provide an audio signal.
❑ When tuned to a digital channel with Alternate Audio, the broadcaster
may not be broadcasting your preferred Alternate Audio language.
Audio noise.
❑ Make sure that the antenna is connected using a 75-ohm coaxial cable (not
supplied).
❑ Keep the antenna cable away from other connecting cords.
❑ To avoid TV interference, make sure to use an undamaged antenna cable.
PC Input
No Picture/No Signal.
❑ Confirm the PC is correctly connected to the TV in the PC IN (HD15 cable
not supplied).
❑ Ensure the output signal from the PC is one of the formats listed on
page 16.
❑ Turn the PC off. Confirm the PC connection and restart the PC. Plug and
play will auto-detect the TV and correctly set up the PC timing.
❑ Check the standby mode of your PC. The TV automatically will enter to
standby mode if there is no signal input.
Poor picture.
❑ Adjust the resolution (page 16).
❑ Adjust Phase (page 32).
BRAVIA Theatre Sync
Cannot find connected
BRAVIA Theatre Sync HDMI
device.
❑ Make sure that the Control for HDMI is set up on both the TV and the
optional device compatible with BRAVIA Theatre Sync (page 19).
Cannot control second AV
receiver.
❑ Only one A/V receiver may be used with the BRAVIA Theatre Sync and
Control for HDMI functions at one time (page 39).
General
Wide Mode changes
automatically.
❑ The current Wide Mode setting is automatically replaced with the 4:3
Default setting when you change the channel or video input, if 4:3
Default in the Screen menu is set to other than Off. If you want to lock in
the Wide Mode selected with
on the remote control, set 4:3 Default
to Off in the Screen menu (page 32).
❑ Turn off the Auto Wide option in the Screen menu (page 32).
Condition Explanation/Solution