Sony MDR-IF540RK - Manual (Page 6)

Getting started
6 GB
5
Connect the supplied AC power
adaptor to the transmitter.
6
Rest the headphones on the
transmitter so that the
headphones’ contact point
meets the transmitter’s contact
pin while making sure that the
charging indicator lights up.
The charging is completed in about
16 hours and the charging indicator
goes off.
When placing the headphones on
the transmitter, be sure to hold them
with both hands so that the right
and left housings are horizontal.
Place the headphones vertically on
the transmitter then tilt them back
as illustrated below.
When the indicator is not lit
Check if the right and left headphones
are rested on the transmitter correctly.
The indicator may not be lit if the
headphones’ contact point does not
meet the transmitter’s contact pin. Take
off the headphones and place them on
the transmitter again so that the
indicator lights up.
To recharge the headphone
battery after use
Place the headphones on the transmitter
after you use the headphones. Since the
built-in timer recognizes when
charging is complete, there is no need to
take off the headphones from the
transmitter after the completion of
charging.
Notes
•The transmitter automatically turns off
while charging the batteries.
•This system is designed to charge only the
supplied rechargeable batteries type
BP-HP550 for safety. Note that other types
of rechargeable batteries cannot be charged
with this system.
•If dry batteries are installed, they cannot be
charged.
•Do not attempt to use the supplied BP-
HP550 rechargeable batteries for other
components. They are for use with this
system only.
•Charge in an environmental temperature of
between 0˚C and 40˚C (between 32˚F and
104˚F).
AC power
adaptor
(supplied)
Transmitter
to DC IN 9V jack
to an AC outlet
Right
housing
Left housing