Sony VPCEL2 Series - Manual (Page 123)

6. Remove the new memory module from its antistatic bag.
7. Hold the memory module by its edge and slide it into the memory module slot with its
end terminal facing downward while aligning the notch on the module with the small
projection in the slot.
8. Hold the memory module by its edge and push in until it clicks into place as shown in
the illustration.
The latches on both sides of the slot snap into place to secure the module. Do not
touch any ICs (black components) on the memory module.
9. Replace the memory module compartment cover and secure it with the screws you
removed in step 3.
10. Install the battery pack and connect all connection cables and peripherals that you
removed in Step 1, and turn on the computer.
11. Check that the amount of system memory has correctly changed. [Details]
If the amount of indicated system memory is correct, memory module installation was
successful.
Related Topic
Notes on Adding and Removing Memory Modules
© 2011 Sony Corporation
123