Sony VPCEC4AFX - Manual (Page 3)

VPCEC Series Hard Disk Drive
Replacement Instructions
P/N 989201984 Rev. B 3/3
Step 12. Re-install the four (4) Hard
Drive Bracket screws to secure the
Hard Drive bracket to the New Hard
Drive.
Step 10. Turn the Hard Drive Assembly
over and slide the Hard Drive downward
to disconnect it from the cable. Step 11. Slide the new Hard Drive in an
upward direction to connect it to the
cable.
Hard Drive Reinstallation
(Steps 13-17)
Step 13. Insert the Hard Drive cable into
the connector. Close the Latch.
Be careful not to scratch the bottom of
the computer with the Hard Drive
Bracket.
Step 14. Insert the Hard Drive Assembly
into the Hard Drive Bay. Make sure the
Hard Drive goes under the screw hole at
the top of the bay. Step 15. As noted in step 7, the
screws in the middle of the Hard Drive
are different than the screws on the
edges. Separate the two (2) like
screws from the remaining five (5) like
screws. Install the two (2) like screws
back into the middle of the Hard Drive,
and then install the remaining five (5)
to secure the Hard Drive Assembly in
place.
Step 18. Re-install the Battery pack
and reconnect the AC Adaptor.
Power on your computer and continue
with the recovery process by following
the instructions described on the back
of the recovery disk’s case.
Step 16. Re-attach the Hard Drive by
sliding the door upwards. Step 17. Re-install the Hard Drive Door
Screws to secure the Door. Return the old Hard Drive to
Sony using the included
shipping instructions.
New Hard Drive