Sony KLV-S32A10 - Manual (Page 63)

Other Information
63
O
th
e
r Info
rm
atio
n
Only snow and noise appear on
the screen. ❑ Check if the antenna is broken or bent.
❑ Check if the antenna has reached the end of its serviceable life. (3-5 years in
normal use, 1-2 years at the seaside.)
Dotted lines or stripes. ❑ Keep the TV away from noise sources such as cars, motorcycles, or hair-
dryers.
No color/Dark picture/Color is
not correct ❑ Press PICTURE to select the desired Picture mode (page 33).
❑ Adjust the Picture Mode options in the Video settings (page 48).
The picture is too bright. ❑ Press PICTURE to select the desired Picture mode (page 33).
Noisy picture. ❑ Make sure that the antenna is connected using the supplied 75-ohm coaxial
cable.
❑ Keep the antenna cable away from other connecting cords.
❑ Do not use 300-ohm twin lead cables as interference may occur.
No sound/Noisy sound
Good picture, no sound. ❑ Check the volume control.
❑ Press MUTING or VOL + so that “Muting” disappears from the screen
(page 32).
❑ Disconnect your headphones.
❑ Set Speaker to On in the Audio settings (page 50). If it is set to Off , sound
is not output from the TV’s speakers regardless of the TV’s volume control.
Audio noise. ❑ Make sure that the antenna is connected using the supplied 75-ohm coaxial
cable.
❑ Keep the antenna cable away from other connecting cords.
❑ Do not use 300-ohm twin lead cables as interference may occur.
❑ Press MTS/SAP to select Mono (page 33).
Striped noise during
playback/recording of a VCR. ❑ This is caused by video head interference. Keep your VCR away from the
TV.
❑ Leave a space of 30 cm (11 7/8 inches) between your VCR and the TV to
avoid noise.
❑ Avoid installing your VCR in front of the TV or at the side of the TV.
Cannot operate settings item. ❑ If the option you want to select appears in a pale color, you cannot select it.
Wide Screen Mode changes
automatically. ❑ The current Wide Screen Mode setting is automatically replaced with the
4:3 Default setting when you change the channel or video input, if
4:3
Default in the Screen settings is set to other than Off . If you want to lock in
the Wide Screen Mode selected with the WIDE button, set 4:3 Default to
Off in the Screen settings (page 51).
Remote control does not operate. ❑ The batteries could be weak. Replace the batteries.
❑ Check the polarity of the batteries.
❑ Press the TV (FUNCTION) button first for TV operation.
❑ Point the remote control at the remote control sensor of the TV.
❑ Install the TV away from fluorescent lights.
❑ Press FUNCTION button for corresponding device you want to control.
Problem Possible Remedies
(Continued)