Sony PEG-NX80V - Manual (Page 14)

14
Troubleshooting
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
My CLIÉ handheld does not work
properly
I cannot turn on my CLIÉ handheld
B The POWER/HOLD switch of your CLIÉ handheld is in the HOLD mode.
Your CLIÉ handheld does not work when the POWER/HOLD switch is
in the HOLD mode. Make sure you release the HOLD mode.
B The battery power of your CLIÉ handheld has run out.
Place your CLIÉ handheld in the cradle connected to the AC power
adapter, then allow it to charge for a few minutes before turning it on. If
it turns on, continue charging for approximately four hours and then
perform a soft reset.
B The connector between your CLIÉ handheld and the cradle is dirty.
You cannot recharge your CLIÉ handheld if the connector is dirty. Place
your CLIÉ handheld several times in the cradle to clean the connector.
The screen is not displayed even though the POWER LED is
on
B The POWER/HOLD switch of your CLIÉ handheld is in the HOLD mode.
The screen is not displayed when the POWER/HOLD switch is in the
HOLD mode. Make sure you release the HOLD mode.
B Perform a soft reset by pressing the RESET button.
b For details, refer to “Basic operations of your CLIÉ™ handheld: Restarting your
CLIÉ handheld” in the “Read This First (Operating Instructions).”
My CLIÉ handheld does not respond
B The POWER/HOLD switch of your CLIÉ handheld is in the HOLD mode.
Your CLIÉ handheld does not operate when the POWER/HOLD switch
is in the HOLD mode. Make sure you release the HOLD mode.