Sony FWD-32LX1 - Manual (Page 10)

FWD-42LX1
FWD-32LX1
6
1 2
4 3
Code Table(1-a)
[a]Function [b]Range/Switch Code Command
Control
Enquiry Standby Power On
0x35 PAP Input Detect (Left/Main) 0x20 INPUT1 DVI No Yes Disable Enable
0x36 PAP Input Detect (Right/Sub) 0x0A INPUT2 RGB No Yes Disable Enable
0x0B INPUT2 COMPONENT
0x0C OPTION1 VIDEO
0x0D OPTION1 S VIDEO
0x0E OPTION1 RGB
0x0F OPTION1 COMPONENT
0x10 OPTION2 VIDEO
0x11 OPTION2 S VIDEO
0x12 OPTION2 RGB
0x13 OPTION2 COMPONENT
0x20 INPUT1 DVI
* 1: Transmit the next command 10 seconds after Power On and Power Off commands are transmitted. If not, correct data may not be able to be acquired.
* 2: For INPUT SELECT, PAP, and Active Picture (SWAP), check the busy state using a Busy to INPUT command.
* 3: The Picture Position arrangement is as shown below.
IP Address
Syntax Header Category Function Data1 Data2 Data3 Data4 Data5 Check Sum
Control 0x8C 0x00 0x42 0x05 Address 0 Address 1 Address 2 Address 3 0xXX
0x00 - 0xFF 0x00 - 0xFF 0x00 - 0xFF 0x00 - 0xFF
Answer Header Answer Check Sum
Control 0x70 0x00 0x70 Completed
0x70 0x03 0x73 Command Canceled
Example of IP Address setting
192.128.14.1
192 (0xC0) Address 0
128 (0x80) Address 1
14 (0x0E) Address 2
1 (0x01) Address 3
* IP Address command can be carried out even in the standby state.
Code Table(1-a)
[a]Function [b]Range/Switch code Command
Control
Enquiry Standby Power On
0x42 IP Address Yes Yes Enable Enable
0x43 BackLight 0x00 - 0x64 Yes Yes Disable Enable
0x44 Illumination 0x00 OFF Yes Yes Disable Enable
0x01 Low
0x02 High
0x45 Control Mode 0x00 Main + Remocon Yes Yes Disable Enable
0x01 Main
0x02 Remocon