Before setting up your tv – Sony KDL-46EX621 User Manual
Page 9
9
D:\Cmeng's JOB\SONY TV\SY0404_W9 (Rev-4)\4275462151_US\US03STU.fm
KDL-EX729/EX723/EX720/EX621/EX620/HX729
4-275-462-15(1)
Getting Started
Guidelines for Remote Control
•
Point your remote control directly at the
IR sensor located on your TV.
•
Make sure that no objects are blocking
the path between the remote control and
the IR sensor on your TV.
•
Fluorescent lamps can interfere with
your remote control; try turning off the
fluorescent lamps.
•
If you are having problems with the
remote control, reinsert or replace your
batteries and make sure that they are
correctly inserted.
Before setting up your TV
Some TV models are packaged with a
detached Table-Top Stand so you can
mount your TV to a wall right away. If you
are not mounting the TV to a wall, you will
need to attach the Table-Top Stand. You
will need a Phillips screwdriver (not
supplied) and maybe also a hexagon wrench
(supplied with some models) and the
supplied screws to complete the task. Look
for the supplied Table-Top Stand instruction
leaflet.
Be sure to consider the following while
setting up your TV:
•
Disconnect all cables when carrying the
TV.
•
Carry the TV with the adequate number
of people; larger size TVs require two or
more people.
•
Correct hand placement while carrying
the TV is very important for safety and
to avoid damage.
•
Ensure your TV has adequate
ventilation, see page 19.
•
For best picture quality, do not expose
the screen to direct illumination or
sunlight.
•
Avoid installing the TV in a room with
reflective wall and floor materials.
•
Avoid moving the TV from a cold area
to a warm area. Sudden room
temperature changes may cause moisture
condensation. This may cause the TV to
show poor picture and/or poor color.
Should this occur, allow moisture to
evaporate completely before powering
the TV on.
•
Ensure that there are no objects in front
of the TV.
•
Do not expose the Presence Sensor to
direct sunlight or other strong light, as
malfunction may occur.
Presence Sensor
IR Sensor
3D Sync Transmitter
(KDL-65/55/
46HX72x, KDL-60/
55/46/40/32EX72x
only)