Sony KDL-46W5150 - Manual (Page 12)

12
Shown with PC connection
Use the TV as a monitor for
your PC by connecting an
HD15-HD15 cable
connection as shown to the
right.
This TV can also be
connected to a PC with a
DVI or HDMI output.
(Refer to the supplied Quick
Setup Guide.)
PC Input Signal Reference Chart
After connecting the PC to the TV, set the output signal from your PC according to the supported
resolutions and timings indicated below.
~
• This TV’s PC input does not support Sync on Green or Composite Sync.
• This TV’s PC VGA input does not support interlaced signals.
• For the best picture quality, it is recommended to use the signals in the above chart. In plug and play, signals
with a 60 Hz vertical frequency will be detected automatically. (PC reboot may be necessary.)
* The 1080p timing when applied to the HDMI input will be treated as a video timing and not PC timing. This
affects Picture settings and Wide Mode settings. To view PC content set Scene Select to Graphics,
Wide Mode to Full, and Display Area to Full Pixel.
Supported resolutions
Horizontal
frequency (kHz) Vertical
frequency (Hz) Standard
Signal Horizontal
(Pixel)
× Vertical
(Line)
VGA 640 × 480 31.5 60 VGA
SVGA 800 × 600 37.9 60 VESA Guidelines
XGA 1,024 × 768 48.4 60 VESA Guidelines
WXGA 1,280 × 768 47.4 60 VESA
1,280 × 768 47.8 60 VESA
1,360 × 768 47.7 60 VESA
SXGA 1,280 × 1,024 64.0 60 VESA
HDTV* 1,920 × 1,080 67.5 60 CEA-861*
PC IN
RGB
AUDIO
IN
IN
IN
AUDIO
R
VIDEO
(MONO)
L
VIDEO IN
S
VIDEO
3
4
2
2
Side panel
HD15-HD15 cable
(analog RGB)
Audio cable
(stereo mini plugs)
• Connect the PC IN jack to the PC using an HD15-HD15 cable with ferrite core (analog RGB) and
audio cable (see page 9).
• The TV enters the standby mode automatically when the PC is connected to the TV and no signal
has been output from the PC for more than 30 seconds, see the online Reference Book for details.