Actiontec electronic IS560LH - Manual (Page 73)

73
The following chart lists the S36 and S48 configuration settings necessary to negoti-
ate certain types of connections:
S48=7 S48 =128
S36 = 0, 2 LAPM or hangup do not use
S36 = 1, 3 LAPM or async async
S36 = 4, 6 LPAM, MNP, or hangup MNP or hangup
S36 = 5, 7 LAPM, MNP, or async MNP or async
S89 Timer to Control Sleep Mode
Range: 0, 5-255
Default: 10
This command displays the number of seconds of inactivity (no characters sent from
the DTE, no RING) in the off-line command state before the modem places itself
into standby mode. A value of zero prevents standby mode.
If a number between 1 and 4 is entered for this register, it will set the value to 5, and
the inactivity before standby will be 5 seconds. This is done for compatibility with
previous products which allowed time-outs down to 1s.
S90 Local Phone Status
0 = local phone on-hook
1 = local phone off-hook
This register tells the status of the local phone. It is read only.
S91 Line Transmit Level
Range: 6-15
Default: 15
Units: 1 dB
This register is effective only for Japan. It specifies the line transmit level in dB with
an implied minus sign.
S92 Direct Connect Transmit Level (default 20)
Sets the transmit level, in dBm for direct connect. This value may have different
settings for different phones.