Sony BDV-N890W - Manual (Page 22)

22 US
Gettin
g
Star
ted
• If security is set on your wireless network, the
security key (WEP key, WPA key)**.
* SSID (Service Set Identifier) is a name that
identifies a particular wireless network.
** You need to check the settings of your wireless
LAN router to get the information about SSID and
security key. For details:
– visit the following website:
http://www.sony.com/blurayhtsupport/
– refer to the instruction manual supplied with the
wireless LAN router
– consult the manufacturer of the wireless LAN
router
About wireless LAN security
Since communication via the wireless LAN
function is established by radio waves, the
wireless signal may be susceptible to
interception. To protect wireless
communication, this system supports various
security functions. Be sure to correctly
configure the security settings in accordance
with your network environment.
x No Security
Although you can easily make settings, anyone
can intercept wireless communication or intrude
into your wireless network, even without any
sophisticated tools. Keep in mind that there is a
risk of unauthorized access or interception of
data.
x WEP
WEP applies security to communications to
prevent outsiders from intercepting
communications or intruding into your wireless
network. WEP is a legacy security technology
that enables older devices which do not support
TKIP/AES to be connected.
x WPA-PSK (TKIP), WPA2-PSK (TKIP)
TKIP is a security technology developed in
response to the deficiencies of WEP. TKIP
assures a higher security level than WEP.
x WPA-PSK (AES), WPA2-PSK (AES)
AES is a security technology that uses an
advanced security method distinct from WEP
and TKIP.
AES assures a higher security level than WEP or
TKIP.
Step 4: Setting up the
Wireless System
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To activate wireless transmission,
perform the following Steps.
1
Insert the wireless transceiver into the
unit.
2
Insert the wireless transceiver into the
surround amplifier.
3
Connect the AC power cord (mains
lead) of the unit.
Before connecting the AC power cord,
make sure all connections in “Step 2:
Connecting the System” (page 17) are
secure.
Rear panel of the unit
Wireless transceiver
Rear panel of the surround amplifier
EZ W-R
T5 0
Wireless transceiver