Sony BDV-N890W - Manual (Page 41)

O
th
e
r O
p
era
tions
41 US
You can control non-Sony components by
changing the preset code of the remote.
1
Press HOME.
The home menu appears on the TV screen.
2
Press C/c to select [Setup].
3
Press X/x to select [Remote Controller
Setting Guide], then press .
4
Press X/x to select [Preset Mode], then
press .
5
Press X/x to select the component type
that you want to operate with the
supplied remote, then press
.
6
Press X/x to select the device’s
manufacturer, then press .
7
Press POP UP/MENU while pressing
the operation mode button TV (for a TV)
or STB (for a cable box, digital satellite
receiver, digital video recorder, etc.).
8
When the TV or STB operation mode
button starts flashing, enter the code
on the TV screen using the number
buttons, then press ENTER.
If you successfully set the code, the TV or
STB operation mode button will flash twice
slowly. If the setting is unsuccessful, the
TV or STB operation mode button will
flash five times quickly.
• You can quit Preset mode by pressing the TV or STB
operation mode button (whichever button is
flashing).
• If you do not operate the remote for more than 10
seconds during presetting mode, the remote exits
from presetting mode.
1
Press and hold AV ?/1 first, then press
VOL –, then press CH –.
The BD, TV, and STB operation buttons
light up.
2
Release all buttons.
The BD, TV, and STB operation mode
buttons turn off and the preset code is
cleared. The remote returns to its default
settings.
Changing the Brightness
of the Front Panel
Display and Power
Indicator
Press DIMMER.
Each time you press DIMMER, the brightness of
the front panel display and power indicator is
changed.
Saving Power in Standby
Mode
Check that the following settings are both made:
– [Control for HDMI] in [HDMI Settings] is set
to [Off] (page 49).
– [Quick Start Mode] is set to [Off] (page 49).
Changing the preset code of
the remote (Preset mode) Clearing the preset code from
the remote’s memory